cantfindausername
28-10-2006, 17:49
Just hooking everything back up, and I've noticed that the wire has severed just at the connector of the o2 sensor on the loom side of the connector.
Will I be alright to just solder/crimp the connector? Its a single wire o2 sensor.
I think it would work ok as its just an elec. signal, but thought I'd check first.
Thanks,
Ant
Will I be alright to just solder/crimp the connector? Its a single wire o2 sensor.
I think it would work ok as its just an elec. signal, but thought I'd check first.
Thanks,
Ant