View Full Version : Help Engine
Ok i'm stuck, i can't get the engine on the stand because i can not find bolts
that are long enough>:(
what did you guys use, and where did you get them
cheers H
Jiff Lemon
09-08-2006, 11:47
had similar problems - I hacked the standoff's on the engine stand down.
Cheers guys,
did same as you jiff, luckily i did'nt take too much off, just enough clearance when engine mounted.
I did'nt get the crank bolt of before i removed the flywheel,
is there any way to get this off, or do i need to take it off the stand and put the flywheel back on??
lodgeman
10-08-2006, 16:07
can you not put 2 opposing bolts in the end of the crank and put a lever in between the two?
Did give it a try lodge but no joy, so tomorrow i'm gonna put the flywheel back on, so engine off the stand back on the crane, etc
Well i put the flywheel back on and secured it, Tried to undo the bolt, it would'nt budge, eventually cracked the socket,
really stuck any ideas chaps ?
Jiff Lemon
13-08-2006, 12:47
they're done up very very tight - I found socket on extension bar, Lock up flywheel, hit extension bar with FBH. It's the shock that helps losen it.
Just to check, to undue the bolt it is the standard anti clockwise direction?
cheers
edit
got the bolt undone, flippin thought it was welded on
It is anticlockwise.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.