View Full Version : mk1a suspension koni replacement
i have springs and shocks and wish to fit, is there a guide with piccies someone can point me to?
Gary Symons
31-07-2009, 14:45
You can download the mk1 manual from here:
http://manual.teq.org/
Should have all the info you need.
many thx Gary, one side off and koni insert ready to go,
are people jerry rigging a peg spanner to tighten the final nut/seal on this conversion? 120 nm torque on the Koni instructions (and I can only find Shimano bike gear peg spanner locally) which isnt something i'd want to guess with my two masonary nails, a spacer and adjustable as substitute tool.
Apologies if covered elsewhere but I couldn't fiond reference to this issue.
(konis bought from larkspeed as part of a kit with springs)
David Sleith
31-07-2009, 17:56
Large adjustable pipe grips do the trick
1944 im doing the same conversion and had the same issue, in the end i just put the old tops on and didnt use the kono piece :P
take it you have either polybushed or that is the next job on the list?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.