Icsunonove
21-05-2009, 16:48
Had a bit of a accident.
On a 1.5 the rev 2 engine has a connector that isn't used. Evidently it's been rubbing on the driveshaft and then has been ripped off completely.
The car is misfiring at the moment and it may / may not be due the bare ends of these wires.
Here's the connector. It's a grey round two pin plug with a blue with white stripe wire and a blue with black stripe wire. There is a short piece of grey plastic tubing about 3" long and then into some black tubing about 12" long.
http://www.twobrutal.co.uk/forum/images/recovered/2009/05/239.jpg
http://www.twobrutal.co.uk/forum/images/recovered/2009/05/240.jpg
Two questions:
1) What's this connector for?
2) Where does it plug into the loom? I can't see where it's been pulled out from.
Thanks in advance,
Tom
On a 1.5 the rev 2 engine has a connector that isn't used. Evidently it's been rubbing on the driveshaft and then has been ripped off completely.
The car is misfiring at the moment and it may / may not be due the bare ends of these wires.
Here's the connector. It's a grey round two pin plug with a blue with white stripe wire and a blue with black stripe wire. There is a short piece of grey plastic tubing about 3" long and then into some black tubing about 12" long.
http://www.twobrutal.co.uk/forum/images/recovered/2009/05/239.jpg
http://www.twobrutal.co.uk/forum/images/recovered/2009/05/240.jpg
Two questions:
1) What's this connector for?
2) Where does it plug into the loom? I can't see where it's been pulled out from.
Thanks in advance,
Tom