Can't pull fault codes...

[Sponge Bob]

Recently took off inlet manny and changed an injector... but on putting everything back together - it's not starting.

Seems that it's not getting a spark, and it won't let me pull ECU codes at all for some reason.

The loom is earthed this time :roll: so not sure what's wrong...

Any ideas chaps (& chapettes)

[Murf]

Is it just one cylinder thats not getting a spark? Check out my problem thread, turned out not to be a faulty injector but the injector resistor pack.
Have you deffo linked out the right diagnostic terminals?

[Sponge Bob]

Yeah - definitely the right terminals...

It's getting no spark anywhere, but the fact it's not pulling codes as well, and that it worked fine before I changed the injector makes me wonder??