- Identifying a Garret turbo / modded 3SGTE
- fuel pumps
- intercooler hardpipes
- drilling/tapping quickie
- Overflow bottle volume?
- How to tell the differences?
- mk2 turbo bits that would be useful for the mk1.5
- starter/clutch query
- sump clearance measurement anybody?
- Charcoal Cannister
- Throttle cable
- turbo question
- Rev 2 engine whats the power ?
- Cambelt tensioner
- Engine mount templates
- Clutch line
- alternator mod
- need info?
- How does a dump valve work?
- 20 valve heads
- bypassing speed limiter
- celica st185 fuel pump
- a few questions regarding 3sgte
- lamba sensors?
- standard position alternator mounting
- Coolant piping
- Rev 3 head on rev 2 engine !
- axle question
- engine s in but unsure if its right
- spark plugs
- fuse box and wires
- coolant pipes from heater
- Boost problem?
- hks f con v piggyback
- bov
- Will the Mk2 provide everything you need?
- What to do about the air con pump ?
- Anyone got a photo...
- hoses! where do they go!
- rebuilding a 3s-gte
- 3sgte power priming
- diy water injection
- Wont Start!!! Help!!!!
- CT26A upgrade from the Supra 7MGTE
- Turbo oil seals gone! need turbo
- Coil/Ignitor
- inline fuel pump
- will st185 rear cv's work aswell?
- boost guage? reverse lights? driving great though
- Are mk1 and mk2 turbo coolant gauge sensors the same?
- Charge coolers? opinions?
- W/a radiator options?
- st185 and 165 charge coolers
- mechanical speedo drive
- JDM conversion question
- Vac pipe question
- rebore question
- TB Thingymajig
- front mount
- various fuel pipes etc
- how to use the twobrutal jig
- Revision identification help?
- those silver boxes...
- Fuel Cut Defenders / Defencers (FCD's)
- Turns over, but no spark
- front torque mount cad files
- Celica bracket mod
- oil pressure sender thread
- 1997 turbo?
- gear cables and modifications needed
- Turbo suggestions... supra CT-26 w/ 60-1 compressor wheel
- fuel injector resistor pack wiring
- got spark but no start
- bolt for bov
- Online 3SGTE (GT4) Tech Manual
- gearbox change
- Cheapest forged pistons anyone ?
- Celica GT-4 st185 swap
- Oil
- how much
- Old Engine Out, New Engine Ready
- another 1.5
- rev2 catalyst removal?
- 3S-GTE Generations question.
- mk1 oil pressure sender location
- fuel pump question
- engine reassemble (HELP)
- Stud size?
- air flow meter swap.
- turbo heat, ouch!
- 3sgte swap
- CT26 inlet size
- high cold idle
- firewall alloy sheet cost
- hose questions
- Comparison pics of 165 and 205 Charge coolers
- Downpipe pics
- Stock TB size?
- Alternator brackets
- sparkplugs
- engine being positioned
- Firewall Template
- afm filter plate
- quick fuel question
- ticky engine
- front torque mount
- Air flow meter.
- VTV bov valve option
- missing ballbearing
- St205 charge coolers and bov s?
- turned the key and>>>>
- my horrible engine noise(soundclips)
- Is the tubby cam belt the same as the NA?
- boost pressure sensor
- Removing Crank Pulley!!
- ST165 GT4 pump ok?
- Is this the knock sensor??
- my custom alternator tensioner
- Engine Question
- CT26 ad CT26a?
- Fuel cut or limiter problem in top
- 4A-GZE ignitor ok for 3S-GTE?
- 3SGTE Jig request thread.
- Gutted - Fuel Everywhere
- waterpump removal
- Mounting the AFM?
- dip stick with celica alt bracket
- rev3 injectors ?
- Anyone ever heard of this stand alone system?
- Custom exhaust manifold
- FAO Tyler, re: US jig...
- cam removal
- heat shield when using celica alt mount
- Blitz de-cat pipe problems
- Knock sensor replacement help !
- Plug leads etc
- 3sgze?
- Ivor's thread
- sw20 rear subframe fitment
- mk2na fuel pump v turbo pump
- oil pump
- yummy yummy yummy...
- Recirc BOV..
- CT26 wastegate opening
- Thread size on xs power downpipe
- Downpipe modifications
- aligning a twin disc clutch
- pillar mounted boost gauge housing
- 3sgte complete gasket set.
- gen 2 fuel rail restrictions
- Injector dimensions
- diff between block
- Rotating turbo housing...
- Celica Mod Alternator Belt
- jdm 3sgte
- ECU swap from rev1/2 to rev3+
- Distributor is moving
- Getting this thing going
- ECU Code 35 - Turbo Pressure Meter
- please check this cam timing and lobe location
- ITS ALIVE!!! (yes I'm shouting!!)
- Rev3 ECU swap progress......
- Removing tvis rail
- Dangers of a bent turbo blade?
- How to remove turbo housing?
- flywheel bolt pcd?
- rev 1 plumbing and fuel pipe identification
- what turbo...
- Turbo shaft/compressor wheel suppliers?
- engine oil.. what to use
- What sound.....
- thread size on clutch 2 way valve?
- Solution to cooling pipe issue
- oil capacity of a 3sgte... ?
- Valve removing tool.?
- AC on a supercharger bodied mk1.5
- fitting a MBC
- celica alltrac
- swap tool list?
- ST165 gt-s to AW11
- Optimum boost for a std 3s-GTE rev1???
- xs power decat support bracket
- rev 2 to rev 3 conversions?
- Changing gearbox oil
- Battery Relocation
- water flow across charge cooler core
- Fuel pump cockup
- Off side engine mount - what fits on top?
- st205 chargecooler inlet temp puzzler
- my rev 1 3sgte rebuild
- Dicktator ECU
- Garage Wall Chart Checklist
- Turbo oilpipe issue.
- Safe max boost level on std rev1?
- Tubing up the rev3.
- 500+ bhp 3s-GTE on mr2oc
- Speedo.....
- SC axle power
- engine sourcing advise
- Weak Turbo Actuator
- Exhausted
- Help needed on fitting boost gauge / fuel cut
- Which head gasket?
- Dump valve
- Flywheel fitment. Good tips on locking it.
- Destroyed Distributor help !
- Running on 3 cylinders??
- rev 1 hesitation
- Hose diameters
- changing turbo in situ
- pulley
- celica na motor mounts
- engine question
- Few niggles - need help!!
- manifold removal?
- Fault code
- new downpipe?
- Rev3 woes... Oxygen sensor
- Cylinder head corrosion, time for new head or should it be ok?
- Actuator Spring. What does it do?
- oxygen sensor.
- leak test smoke
- Wiring the MK1.5
- rough running, but I want cool runnin!!
- Boost problem
- turbocharger pressure gauge?
- swap alternative ?????
- Just a quicky. Two connections?
- Gret timming
- Boost gauge fitment
- Rev 3 3SGTE BGB?
- Valve stems seals, where do the green ones go?!
- HKS BOV plumbing
- Fitting a rev 3 timing belt properly!!?
- oil in intake
- Code 34
- Removing a superchip
- MSD Activator Window Switch - Experiences?
- colder grade plugs
- SW20 turbo removal time
- 2.2L stroker for the 3SGTE?
- 3sgte ecu's
- No boost rev3 turd...bo
- Fuel Pressure Regulator
- overrun fuel shut off
- Shifter Cable problems
- No Oil Pressure Gauge?
- Power FC mapped!
- Standalone ECU options
- Fuel Injectors