Hi guys, well I have had a day off and decided to give this conversion a go, so here is the pic of the mocked up final assembly, seat just tacked on for now as wanted to make sure it lined up ok.

It was one hell of a job getting the 20 year od gland nut off, had to heat it with oxg acet in the end....I had to drill out the blue hat a bit but apart from that and a good bit of grinding then it all seemed to go ok.



I am completing it a side at a time so I have th front mocked up as well but I have a question about the below....



The red remnence is some kind of rubber\ foam dust cap for the bearing.... Whats the best option to replace this?