exhaust concern

[cantfindausername]

That might explain it :D

[cantfindausername]

Ok I'm planning out the exhaust additions that need to be made to Ninas v6 install. So I'm gathering that the aluminised jetex pipes are a good source to use for bends and so on.

Their flanges seem expensive, so I'm looking at other sources for those.

So that mainly leaves the flexi sections. I assume that its best to have one on both of the pipes from the manifolds somewhere before they join the single pipe for the rest of the exhaust.

So, to save a bit of cost, would this be a good alternative for welding into some 2" pipe?? :hidesbehi

http://www.4wheelplay.co.uk/bosal-mi...-25002299.html

I'm also getting a groovey little clarke 160TE mig welder for my birthday so I can do this stuff myself and then play around with exhaust configs on my turbo. Really looking forward to it!!

Any comments or tips on the above appreciated as always!


Ant