but without the 'thanks'..
but without the 'thanks'..
lol, not like me, but back on to the offset subject,
it says we are 4 x 100.....
my Rev 1 is 5 stud, but i am changing to rev 3 tubby hubs, are they different? if so, what alloys do i need, size wise?
RJEvans - Project 3SGTE Widebody
Shepton Mallet - Somerset
All mk2 are 5x114 that's the configuration of mm in a circle of the studs so 5 studs by 114mm, then you have your offset how deep your dish is most standard dish is 35 if you want more sticking out your car you have to lower the offset my rims on the back are 20 so they stick out more and have a deeper dish, you can go to 12 though or lower if going custom.
If you higher the offset you put more if the wheel into the car.
So 5x114 9 et 35 is a 5 stud 114mm 9 inch wide rim with a 35mm offset.
You probably want 10inch rears with a low offset like 12 on the back, most of them are 18s though not many 17inch rims out there, you may still need spacers just depends on the trd kit, also check that the rims clear the brake setup your using.
I bought my rims from rarerims they were very helpfull give the web page a browse, it took me three months to finally get the rims I wanted in all the correct sizes good luck.