1MZ VVTi air intake budget soloution

[1MZVVTi]

I REALLY wanted one of Woodsport's lovely intakes for the dual throttle body VVTi 1MZ.
Paul indicated early on that it was not available to non Woodsport builds.( I see that's changed)
So I prowled the internet for an off the shelf solution.
What I came up with cost a little less than $150 USD but get's the job done without looking too dodgy.
My US spec 1MZ uses the large MAF so the intake tube works a treat.
I tried my best to load pics but the loader just wont do it.
I have to say that the quality is quite good on these I shortened one leg on the Y pipe and the elbows are 2,5" to 2" reducers so it works out nicely.

couldn't get but the tiniest of pics to upload

Attachment 3165

https://www.ebay.com/itm/Aluminum-Y-...72.m2749.l2649


https://www.ebay.com/itm/3-Aluminum-...72.m2749.l2649


https://www.ebay.com/itm/2-5-to-2-63...72.m2749.l2649

I'll try to get at least one install pic to load/