Has anyone got a picture of the rear bulkhead clearance required for the inlet manifold. All the other build thread photos showing this area seem to be missing
Has anyone got a picture of the rear bulkhead clearance required for the inlet manifold. All the other build thread photos showing this area seem to be missing
I'm doing one right at this very moment so will take a pic for you today.
Ah Paula, you little diamond
Sent from my SM-G920F using Tapatalk
Is the cross member at the top trimmed back on the engine bay side?
No I just flatten the top edge and seam seal it.
Sent from my SM-G920F using Tapatalk