Since my introduction thread, I haven't really posted anything but I have been lurking a lot! I thought it was about time that I updated my intro thread into a proper build thread!
So after getting my cheapo roadster - http://www.twobrutal.co.uk/forum/sho...st-Engine-Swap
It passed its MOT after I had done some light maintenance.
Had a problem with the steering not acting how it should. So I replaced the Steering UJ, which helped a little bit.
Next step, put some new rubber on. I had some Team Dynamic wheels with R888s on, but once I fitted them, it really didn't suit the car as they where far too big! So I have decided, once I have recouped a bit of money, I will be getting some Enkei RPF1s. In total, all four wheels will only add up to 9.5KG! 9.65lbs front and 11.3 lbs rear. Should hopefully reduce unsprung weight by a fair bit and really help the car accelerate when the power goes down. But, in the meantime, I put some AD08Rs on the OEM wheels to try and cure the steering problem. Again this helped a lot, but it still wasn't perfect. I also had the car weight, 980KG, so with the heavier engine going in, with new suspension and wheels I plan to keep the car under 1000Kg!
The mk3 steering wheel is massive, so swapped that out for a smaller OMP one, much nicer to drive now, feels a lot more direct.
Then next step of the steering problem was to replace the suspension. I bought some BC coilovers, rear ARB and some new droplinks. Fitted them, reduced the ride height and looked a lot better. This has practically cured the steering problem! I still have a few bits to do, replace the PS fluid, new front arb, and bushes and rear traction rods. Then a geo and I have no doubt it will be much better.
Unfortunately I found this suspension a bit too stiff, even on the soft settings. So back off they came, sold them, and now waiting for a delivery of the new MeisterR ZetaCRD+ coilovers :)
Bought and fitted a hardtop as well, I think it makes them look a lot better.
Paul is now ready for my car to go up there! So as soon as the new coilovers are delivered and I fit them, off it will go for Pauls magic work!
Hopefully I will keep this updated throughout the engine work.