Anyone know what size unions we need for a Mk1 MR2? Thinking of renewing all the brake pipes for nice kunifer ones.
Anyone know what size unions we need for a Mk1 MR2? Thinking of renewing all the brake pipes for nice kunifer ones.
I hate all southerners. As a point of reference, I'm stood at the north pole.
As far as I know, all fittings are M10, at least I'm hoping so, as that's what I've gone a bought!
iirc its m10 x 1 . if you can hang around until the 29th i'll measure for you . alternatively, find a standard manifold nut (m10 x 1.25) see if it just starts on the thread but wont go down, it will be m10x1 if it doesn't go but just starts (hangs on)
......in the bluecorner , fighting out of japan....
Take a pic jiff of it there is so many different ones to get the right ones I see so many people put the wrong ones in because a unf one fits in metric but wobbles a little which is wrong or fit a flange one in a non flange hole so you only get 3 threads in not good . But show me a pic I sort you some out as I buy these by the 100s .:-)
the banjo bolts are all m10 x 1mm
edit: if its any help, the brake pipes are 3/16" and the clutch pipe is 1/4"
Last edited by inglismark; 13-03-2015 at 20:26.