-
Had a bit of a blonde moment with the Alternator, I was thinking too much, 12v+ then internal rectifier switches to ground when the Alternator starts to charge. Same as toyota
Added Note
The original toyota ECU runs a canbus (TX/RX, toyota call it MPX1/MPX2) to the combination unit, this feeds ok commands back and forth, I've found that simple things like the handbrake light won't go off unless the engine ECU detects the alternator charge light function, Basically I need to have the Toyota ecu connected up, I've also checked signal calibrations for my VEMS tachometer output (12+ pulled to ground to give pulse). Now reading as desired, I'll calibrate the tacho via the VEMS when it's dyno'd.
I fabricated a fuel tank a while back using a vw passat fuel pump and sender unit, unfortunately an earlier toyota fuel sender test ended up in flames, so I didn't have a reference for the correct type of resistive signal back to the gauge (combination meter) I tried everything to get a reading and turn off the low level light, but to no avail.
A recent purchase from ebay for a toyota complete pump/sender unit has now enabled me to get the gauge working, I've got to encorporate the toyota fuel sender into the VW package, thankfully not too much hassle.
My original reason for the post was to ask about the slow movement of the gauge, I was checking out all voltages and ohm readings to and from the gauge, all parameters seemed to conform to the toyota specs but I couldn't get the gauge to move, I went into the house to look at another dial set and left the ignition on by mistake, 3/4hr later I came back into the workshop and the gauge was reading full! so it's fine
My Question is: Are these gauges dampened this much, I realise the integrated circuit controls the voltage to the gauge, just need to be sure they are really slow to move, I approximate about 20mins empty to full, I haven't checked if the combination meter speeds up it's rate of voltage change if the engine's running.
cheers
Darren
-
More Ferrari like exhaust note.....?
Please sir, can i offer the flat plane Vs cross plane explanation again?
-
Maybe I should have explained my ambition a little more- to produce a 'replica' that I'm realistically happy with. I'm aware of the flat/cross plane-firing order- head design obsticles for my build and therefore the type of pulse generated by the ferrari design. This topic was covered 4 years ago in my build, the object is to get as far away from the American v8 burble as possible, I may look into the Helmholtz theory and design a little further down the road.
D
-
Fair play. Should be interesting, and I think achievable with some creative exhaust manifold design...
-
Having a bit of fun around the track
https://youtu.be/HTIHrO6iP4I
Darren
-
Damn that sounds good!
Sent from my E5823 using Tapatalk
-
Fantastic job, very well done.
TB Quote of the month:"I split my ear open whilst masturbating" - Jasper Full story Here
-
Should post a little more often
Car at the dyno after having Gunni (vems ecu programmer guru) calibrate the ecu ready for mapping
https://www.youtube.com/watch?v=EJeQSuejAh8
An update of the car at home
https://www.youtube.com/watch?v=f7j21Ip3AU4
Here's how she looks at the mo:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules