Cheers just seen it now :-)
Cheers just seen it now :-)
The passenger door rubber all set
HID kits arrived today
Passenger window trail fitted
Made round brackets for the low beam HID
All completed and left to dry
Ok the side light arrived all the way from Hong Kong only took 3 weeks
Side light LED lit up
Main healight beam working HID
Low beam and side light all working
Bit of wiring for the rear lights a pain but am getting through it
Nearly all wires ran (number plate only used to position number plate light)
Booth and spoiler back on
One of the rear lights alot of wiring going on here
What's the subwoofer in the boot for?
Der Lamborghini engine noise generator.
@ Goldy - For this baby http://www.soundracer.se/
@ Snowtrigger - :-)
Drivers door all gaped
Ok got the passenger side indicators working back and front am using one of the headlights to test them
Reverse light on its bright
Wiring harness for all of the LED's what a pain of a job
Time for the lambo to be pulled out for the monthly unit clean
Bit of sanding on the drivers A pillar
Made this bit and fiberglassed it in place
Sills all fiberglassed and left to dry out over night
I have to say its looking good, there's a hellofa lot of work gone into this. I was wondering, is the roll cage staying? Also I take it the choc block wiring is only a temporary solution?
I hope the cage is staying, i've seen the video of these kits under construction and my only criticism is that the whole roof is removed (as we all know it's integral to the monocoque working) and it is replaced with very substandard 20mm box section which then has the FG roof bonded onto it..... that's not enough, not even close.
I'd say a cage is essential in one of these.
Posting Permissions
Reply With Quote
