A few pin holes to be done
Made headlight brackets and the work perfect :-) the coca-cola tops push the whole headlight up and keep it tight
Headlight all in and lens all cut to shape
All sanded ready for more primer
Re-primered
A few pin holes to be done
Made headlight brackets and the work perfect :-) the coca-cola tops push the whole headlight up and keep it tight
Headlight all in and lens all cut to shape
All sanded ready for more primer
Re-primered
Got the drivers side headlight all wired up
Passenger side spagetti junction nearly there another day or so on this side
Audi v8!!! I'm just guessing, I'm not a mechanic or anything.
SPYDERMAN
@ nu_york - nope it wont fit camry v6 maybe
Made the passenger side headlight brackets
Headlight in
Headlight in just a few bits to do
Headlight lens nearly in
HID's all working
Door cut out
A bit of weight added to keep the lens in position
Door cut out just have to finish the sills
Passenger side headlight in
Collected this back from the company that carbon fibered it
Petrol cap section
Closing panel on the passenger side
Dang that's too bad. You need a v6 that's throaty though!!!! Toyota v6s are raspy. What about a Nissan VQ? You could use the maxima tranny for a transverse. Like I said, I'm no where near being an expert.Originally Posted by peggyontherun
SPYDERMAN
Headlight surround sprayed
Passenger side headlight being set in place
Drivers door cut out
Passenger side door cut out
Gap re-filled just need to be sanded
Headlight lens in just a bit of snagging left to do
Been sanding to get the door gaps
Indicators working :) videos for ya
The rear lights working
Posting Permissions
Reply With Quote
