Timing map for 3vz-fe turbocharged

[400sx]

Ok i have 2 new Erestic head gasket ... Hope that he take 0.90 bar of boost ...

Thanks

[400sx]

Hi, some news ... Not to good !!! I blown the two heads gasket onli 20km after starting to tune the ECU LoL
Whif 0.70 bar of boost ...
Erestic are very weak gasket !
I just buy two Ferriday bi metal head gastek and ARP bolt for my 3VZ

Will take picture of the old and new HG

If some one has advice for me about Ferriday HG ...

thanks

[400sx]

Ferriday Bi-Métal

[hmmmmm]

Looks good and proven to hold up fine with some boost so should be fine. How did it drive before the gaskets blew?

[400sx]

Before blown it was very funny to drive !! Lots of torque at low rpm ...
Turbo spool at 2500 rpm
I was very happy !!! but only 20km Lol...... hope it hold a bit longer this time !

I down the RV to 9,2:1 how many boost in max can i put ?

[Bev]

Where did you mount your intercooler?!

[Nod]

Just FYI really. I mapped a 1uz-fe with 10:1 CR and it ran 1.5bar of boost from a Greddy T88 (we reckon about 600bhp). Was still running the last I heard and it's had death around the ring. This was a Stock NA engine with stock cast pistons and rings and no internal mods. Don't be shy wind that pressure up ;)

[Bev]

What happened to this car out of curiosity?