12

thread: Charge Cooler install step by step, Lots of pics

  1. #11
    OohMatron's Avatar
    Aug 2006
    Leicester
    300
    If you have a look in the very first picture you can see a small pipe leaving the CC core near the inlet from the turbo.

    The BOV fits there :thumbsup:

    You can also see in the very last finished picture the blue pipe coming off that small outlet to the BOV.

    Cheers
    Stephen
    Calling No. 25 1.5 SE

  2. #12

    Dec 2009
    cali
    16
    I just have one question. So i do have the celica acceleratet bracket. But when hooked up my throttle cable is too far out and the hrottle is held slghtly open. Did anyone else have this prblem and any ideas to get around this?

  3. #13

    Dec 2009
    cali
    16
    the celica bracket sits further back then the stock bracket and holds the throttle slightly open

  4. #14
    OohMatron's Avatar
    Aug 2006
    Leicester
    300

    Charge Cooler install step by step, Lots of pics

    the celica bracket sits further back then the stock bracket and holds the throttle slightly open
    Yeap, had that problem too!

    Had a friend cut it and weld it in a better location.
    Stephen
    Calling No. 25 1.5 SE

  5. #15

    Dec 2009
    cali
    16
    Well crap since i dont have a welder and dont have a friend that can weld. You think it would be solid if i just cut it and put 2 bolts throgh it?

  6. #16
    OohMatron's Avatar
    Aug 2006
    Leicester
    300

    Charge Cooler install step by step, Lots of pics

    Well crap since i dont have a welder and dont have a friend that can weld. You think it would be solid if i just cut it and put 2 bolts throgh it?
    I can't see why not?

    It's not being exerted to any major loads vertically or horizontally?
    Stephen
    Calling No. 25 1.5 SE

  7. #17

    Dec 2009
    cali
    16
    well here goes my fix. cut in half and two bolts!


12

  •