How did you wire your positive wire up on the pump?

[Steve-O 2009]

Just wondering whats the best way to wire the positive wire up on the pump? I was just going to solder the Positive / Live wires together but thought if I wanted to remove it it would be better using these Bullet connectors like this? -



but then thought it might vibrate loose over time what do you think?

Thanks

[adamh]

solder everytime!. then some heatshrink / tape. i would not use them unless i had too.
there should be a plug somewhere along the live feed to the pump, use that for disconnection.

[Steve-O 2009]

well I soldered it in the end anyway :)

Just need to finish bending the pipes on the core then thats it nearly done :)