when i did a search i couldnt find a write up on this so decided to have a go :)
i put the car on ramps as it made things a lot easier, but i guess having the side in question on an axle stand would almost as good
take out the liners, the front one under the headlight and the arch liner
remove the head light suround
there are 4bolts inside the head light area, 1st one at the back
2nd bolt below 1st
next 2 on the side near the front of the headlight retract area
open the door and another bolt
2 bolts holding the wing to the valance (lucky for me my wing had rotten away, not)
the next 4 are deep inside the front arch, bolts holding the wing onto the front bumper
these are the top 2
and these are the bottom 2, they were rusty as hell
remove the side skirt
then the barsteward, follow the door/wing gap all the way down to the bottom of the wing and underneath you find this
but i found the cure
to end theres 4 easy ones
then a bit of a jiggle and there you go