when i did a search i couldnt find a write up on this so decided to have a go :)

i put the car on ramps as it made things a lot easier, but i guess having the side in question on an axle stand would almost as good

take out the liners, the front one under the headlight and the arch liner

remove the head light suround

there are 4bolts inside the head light area, 1st one at the back


2nd bolt below 1st


next 2 on the side near the front of the headlight retract area



open the door and another bolt


2 bolts holding the wing to the valance (lucky for me my wing had rotten away, not)


the next 4 are deep inside the front arch, bolts holding the wing onto the front bumper
these are the top 2


and these are the bottom 2, they were rusty as hell


remove the side skirt
then the barsteward, follow the door/wing gap all the way down to the bottom of the wing and underneath you find this


but i found the cure


to end theres 4 easy ones


then a bit of a jiggle and there you go