-
Yep, that'll work just fine, back in the day when I did over 350 3vz installs I used to cut the oil level sensor out of the loop entirely, they were too prone to failure and causing unnecessary problems for customers, so we just ran the AFM W/B to ground to eliminate it.
Happy to have saved you the cost of buying an AFM though :)
-
remind me to send some doombar your way next time im up your way :) its handy living a few miles from the brewery :)
-
-
Just out of curiosity, would this be the same on a 3s-Gte, and perhaps be why mine wont start (AFM isnt connected)
-
No the 3s grounds the COR via the ECU which takes the engine running signal from the igniter. Tommy try grounding the G/R COR wire and see if your pump runs, I tested your wiring here and it was all correct.
-
Will do. Wouldn't run without being bridged which sounded a lot like this. I'll test grounding as you say and see where it takes me.