rev 3 COR wiring

[inglismark]

Hi all

Just a quick question regarding the cor wiring, the guide states that on the rev 2,k the green and red wire from the mk1 COR is attached to a14 on the ecu plug, is this the same for the rev3 3sgte?

Many Thanks,
Mark

[adamh]

the red and green wire should be the same on the mk1. the ecu pin for the rev1 3sgte is +B (A13)
i think would be looking for the +B pin on the rev 3 ecu pinouts, unsure what it is, must be a pinout diagram somewhere, pinouts may be printed inside the ecu on the boards. this may help as the original was based on a rev1 wire up.

http://www.twobrutal.co.uk/forum/images/recovered/2014/11/69.jpg

[inglismark]

according to the wiring diagram, the green and red is supposed to go to pin b17 on a rev 1 or pin a14 on a rev2, ive checked inside the ecu and pin a14 is marked as fc which I can only assume is fuel cut??? looking at your pin diagram, b17 is also marked as fc so I think im good with green and red to a14

[cdwood2010]

Fuel control. That's the COR holding wire iirc.

C.