MkII_5SFE
24-10-2011, 21:18
Ive had the most frustrating time ever getting my 3vz to run.
i followed paul woods guide 5 times over.
ive checked all my grounds. (1.2 ohm or less)
ive checked all my wires, even clutch to cor...
my issue is this.
the engine will try to start as normal. i know all my relays work (checked them out too). but there is no fuel.
when i jumper 12v + to the pump primary wire, it runs, i can hear the fuel pump running
when i try to start it while jumpered, it fires off a few cylinders at a time, then stops.. never does it continue to try to run.
http://www.mr2oc.com/showthread.php?...99#post4835299
that link is my current status.
if you have any tips or ideas, please
I need this car to run in 5 days or less so i can ship it to my next duty station
this is the only thing keeping me from driving this bad-boy.
( i metered all wires out before connecting, 5sfe to 3vz swap)
thank you for any assist
Eric
i followed paul woods guide 5 times over.
ive checked all my grounds. (1.2 ohm or less)
ive checked all my wires, even clutch to cor...
my issue is this.
the engine will try to start as normal. i know all my relays work (checked them out too). but there is no fuel.
when i jumper 12v + to the pump primary wire, it runs, i can hear the fuel pump running
when i try to start it while jumpered, it fires off a few cylinders at a time, then stops.. never does it continue to try to run.
http://www.mr2oc.com/showthread.php?...99#post4835299
that link is my current status.
if you have any tips or ideas, please
I need this car to run in 5 days or less so i can ship it to my next duty station
this is the only thing keeping me from driving this bad-boy.
( i metered all wires out before connecting, 5sfe to 3vz swap)
thank you for any assist
Eric