View Full Version : What do i need to strip from my 3SGE?
Ok now that the engine is out i'm going to start at taking the gearbox off tomorrow as well as the starter, but what else to i need to keep, do i need any of the wires, i think i need the plugs that went to the 2 fuse box? Do i? Anythink else i will be needing?
Cheers
Mark
Are you using the same gearbox? if you are you don't need to remove the starter.
You need all the connectors from the MR2 Fusebox.
There's a starter relay in the boot next to the MR2 ecu whihc you need to keep with the plug and some wiring to connect to the camry loom.
Make sure you get the engine bay fan connector.
jimgreen
25-05-2008, 13:44
If you can, keep the whole loom. There are lots of nice bits and pieces you can use.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.